How to change your gobo lens
COLIFINE logo projector light easy to replace the gobo lens
Before you start, safety is the most important thing. Make sure your LOGO projector is turned off and unplugged, if the gobo lighting has been using the projector will produce high heat, it must be turned off and completely cooled before installing the lens, to prevent burning hands when installing the gobo lens.
Step 1 :
Step 1 :
- Put the gobo projector on a stable workbench or table is the best
- unscrew the projector lens, take out the gobo lens
- clean the gobo lens
- carefully put the new gobo lens into the projector card slot
- use the fixed ring to lock the logo lens
- screw the projector lens to completely install the gobo lens.
Step 2 :
Test:
Plug in the logo projector, turn it on, and point the projector lens at a flat surface. Check the sharpness of the new lens by adjusting the projector lens focus to make the projection pattern clear.
Safety check:
Finally, make sure all parts are safe and the projector is assembled correctly to prevent any damage or danger.
Troubleshooting Tips:
If you encounter any problems along the way, please refer to our detailed FAQs or contact our customer support team for assistance.
Plug in the logo projector, turn it on, and point the projector lens at a flat surface. Check the sharpness of the new lens by adjusting the projector lens focus to make the projection pattern clear.
Safety check:
Finally, make sure all parts are safe and the projector is assembled correctly to prevent any damage or danger.
Troubleshooting Tips:
If you encounter any problems along the way, please refer to our detailed FAQs or contact our customer support team for assistance.
Look at the video below ⬇️⬇️⬇️⬇️⬇️⬇️
Learn more about the gobo projector ⬇️⬇️⬇️⬇️⬇️⬇️
